The reason to fit the pressure gauge is to investigate the Cooling Water Pump problem and condenser performance. On each inlet and outlet leg there are stubs fitted with isolating valves and blank flange. Isolate, remove flange and drill and thread to suit pressure gauges. (Note one inlet leg has no isolating valve) Suggest gauges have to be as fitted on CW discharges i.e. SS 150MM dia, range 0 to 6 bar. See attached Photos.
On the outlet sides propose to fit gauges at lower level to make reading easier by piping impulse line down to suitable mounting location.
On the outlet sides propose to fit gauges at lower level to make reading easier by piping impulse line down to suitable mounting location.
